Display Assembly Instructions are easy to follow instructions for the rotating table-top display available to Paparazzi Independent Consultants.
Step 1: Remove all pieces from the box. There should be a total of seven. Follow all Display Assembly Instructions.
Step 2: Remove all packaging material to reveal individual pieces: 4 Pegboards, 4 Mirror Strips, 2 Square End Pieces with Grooved Edges, 1 All-Thread Rod, 1 Base, 1 Spinner Base.
Step 3: Remove washers, nuts, and acorn nut from the all-thread rod.
Step 4: Thread the rod through the hole in one of the square end pieces. Attach one washer followed by the acorn nut to the side of the square end piece without grooved slots along its edge. Tighten to secure. This will be the top of your finished display.
Step 5: Flip the square end piece face-down: the acorn nut should be facing down and the slots of the square end piece facing up. Slide each of the pegboards into the grooved edges of the square end piece and attach the mirror strips on each corner. Press the pieces into place from the side and do not slide them vertically. Note: Make sure the same ends of each pegboard are facing the same direction to ensure an even display.
Step 6: Thread the exposed end of the all-thread rod through the hole in the other square end piece and slide the pegboards into its grooved edges.
Step 7: Screw a nut onto the end of the all-thread rod to secure the square end piece.
Step 8: Place the flat side of the ball-bearing spinner base into the ridge on the circular base.
Step 9: Slide base onto the all-thread rod.
Step 10: Place washer onto the end of the all-thread rod.
Step 11: Screw the remaining two nuts on top of the washer to secure.